5,474 research outputs found
Experimental Study of the Effect of External Signal on Microwave Oscillations in a Nonrelativistic Electron Beam with Virtual Cathode
The effect of an external harmonic signal on the characteristics of microwave
generation in a nonrelativistic electron beam with virtual cathode (VC) formed
in a static retarding electric field (low-voltage vircator system) has been
experimentally studied. A significant increase in the vircator generation power
is observed when the frequency of the external signal is close to the frequency
of VC oscillations. At large detunings, a broadband chaotic generation is
observed.Comment: 3 pages, 2 figure
Experimental and Theoretical Investigation into the Effect of the Electron Velocity Distribution on Chaotic Oscillations in an Electron Beam under Virtual Cathode Formation Conditions
The effect of the electron transverse and longitudinal velocity spread at the
entrance to the interaction space on wide-band chaotic oscillations in intense
multiple-velocity beams is studied theoretically and numerically under the
conditions of formation of a virtual cathode. It is found that an increase in
the electron velocity spread causes chaotization of virtual cathode
oscillations. An insight into physical processes taking place in a virtual
cathode multiple velocity beam is gained by numerical simulation. The
chaotization of the oscillations is shown to be associated with additional
electron structures, which were separated out by constructing charged particle
distribution functions.Comment: 9 pages, 8 figure
Materials Contrast in Piezoresponse Force Microscopy
Piezoresponse Force Microscopy contrast in transversally isotropic material
corresponding to the case of c+ - c- domains in tetragonal ferroelectrics is
analyzed using Green's function theory by Felten et al. [J. Appl. Phys. 96, 563
(2004)]. A simplified expression for PFM signal as a linear combination of
relevant piezoelectric constant are obtained. This analysis is extended to
piezoelectric material of arbitrary symmetry with weak elastic and dielectric
anisotropies. This result provides a framework for interpretation of PFM
signals for systems with unknown or poorly known local elastic and dielectric
properties, including nanocrystalline materials, ferroelectric polymers, and
biopolymers.Comment: 20 pages, 3 figures, 1 table, accepted to Appl. Phys. Lett. (without
Appendices), algebraic errors were correcte
Role of Single Defects in Electronic Transport through Carbon Nanotube Field-Effect Transistors
The influence of defects on electron transport in single-wall carbon nanotube
field effect transistors (CNFETs) is probed by combined scanning gate
microscopy (SGM) and scanning impedance microscopy (SIM). SGM reveals a
localized field effect at discrete defects along the CNFET length. The
depletion surface potential of individual defects is quantified from the
SGM-imaged radius of the defect as a function of tip bias voltage. This
provides a measure of the Fermi level at the defect with zero tip voltage,
which is as small as 20 meV for the strongest defects. The effect of defects on
transport is probed by SIM as a function of backgate and tip-gate voltage. When
the backgate voltage is set so the CNFET is "on" (conducting), SIM reveals a
uniform potential drop along its length, consistent with diffusive transport.
In contrast, when the CNFET is "off", potential steps develop at the position
of depleted defects. Finally, high-resolution imaging of a second set of weak
defects is achieved in a new "tip-gated" SIM mode.Comment: to appear in Physical Review Letter
Status report of the baseline collimation system of CLIC. Part II
Important efforts have recently been dedicated to the characterisation and
improvement of the design of the post-linac collimation system of the Compact
Linear Collider (CLIC). This system consists of two sections: one dedicated to
the collimation of off-energy particles and another one for betatron
collimation. The energy collimation system is further conceived as protection
system against damage by errant beams. In this respect, special attention is
paid to the optimisation of the energy collimator design. The material and the
physical parameters of the energy collimators are selected to withstand the
impact of an entire bunch train. Concerning the betatron collimation section,
different aspects of the design have been optimised: the transverse collimation
depths have been recalculated in order to reduce the collimator wakefield
effects while maintaining a good efficiency in cleaning the undesired beam
halo; the geometric design of the spoilers has been reviewed to minimise
wakefields; in addition, the optics design has been optimised to improve the
collimation efficiency. This report presents the current status of the the
post-linac collimation system of CLIC. Part II is mainly dedicated to the study
of the betatron collimation system and collimator wakefield effects.Comment: 25 pages, 13 figure
- …